Climbing hold with simple design made of POLYURETHAN. It is suitable for climbing profiles up to 60° angle and roofs.
This model has a special texture – DEEP GRIP. It is created by surface treatment in two steps – by blasting the coarse-grained fraction under high pressure, which is then ground and treated by applying a finer grain size.
- The first, deeper layer prevents rapid wear of the grips.
- The second, with a finer grain size, creates a pleasant surface – the grips are not too rough at the beginning of use.
|Holds in set:||1|
|Type:||Roof Jug, Jugs
|Usage – angle||0°- Roof
|For installation on wooden surface 18-20mm (plywood, particle board…)|
|Wood screws 4,5×40||7pcs|
|Fasteners are not included in climbing set|
|All climbing holds are suitable for outdoors and indoors use.|
© Anatomic 2020, Design by Marek Repčík.